- A jig to file one side of a 6mm brass rod for the nut.
- On the other side I will file small dents for the strings
- The nut
- 2 holes on the flat sides
- small rods to keep the nut in place on the fingerboard
- holes on the fingerboard
- The nut is made of brass and through the small rods it makes a good electrical connection with the grounded fingerboard. This way, the strings that are not pressed stay at a well defined level.
- A jig to cut the brass pegheads
- Pegheads will be 20mm
- Drilling the hole for the strings
- Filing a slot so you can turn the peghead with a screwdriver
- A finished peghead. Its bottom is slightly conical and roughened so it will sit quite tightly and will not move unless you use a screwdriver.
- peg one
- The saddle is made of hard wood. On this side of the fingerboard the strings have to be electrically isolated from each other.
- The underside is cut away to leve place for the cabling.
- Small hole to attach the cables to
- The saddle is kept into place with two dowels. I will not glue them to the fingerboard so it can easily be removed should this become necessary
- On the saddle side, the string is held by a small bead.
Tomorrow I’ll stop working on the bass for a moment and we’ll tackle the flight case for the videobass amplifier…